|
 |
|
|
How To Tune Your Drum Kit |
|
Unlike guitars or pianos, drums can be tuned any way you want! However, to
sound their best, they need to be tuned carefully. Follow the instructions
below and you'll have great sounding drums in no time!
1) Tune each head evenly: Choose any drum (other than the snare drum...we'll
save it for last) and loosen all of the tuning rods on one side then
retighten them finger tight. Tighten each rod 1/2 turn using the criss-cross
sequence shown below.
|
Repeat this procedure until the drumhead is
free of wrinkles and a tone is produced. Tap the head next to each tension
rod as shown and listen to the sound. |
If the sounds you hear are the same note or
pitch all the way around, you're in luck—this is what you want! However,
chances are you won't be this lucky and the sounds will be "high" at some
tension rods and "low" at others. Our goal is to get them to be the same
note all around…here's how we do it. At the places where the pitches were
"high," loosen the rods by 1/8 turn. Where the pitches were "low," tighten
the rods by 1/8 turn. Again, tap the head at each tension rod and note your
progress. Continue this procedure until the head has the same pitch all
around, or as drummers say, "is in tune with itself."
Turn the drum over and repeat the entire process on the other head.
2) Tune the heads to each other: Next we need to tune the top and bottom
heads relative to each other.
Note: There are three ways that this can be done: 1) the top and bottom
heads can be tuned to the same pitch; 2) the top head can be tuned higher
than the bottom; or 3) the top head tuned can be tuned lower than the
bottom. There's no right or wrong method…experiment to see which sounds best
to you.
For now, we're going to tune the top and bottom heads to the same note.
Select a drum and tap the top and bottom heads to determine which is higher.
If the pitches are the same, you're in luck—go to the next drum. If they're
different, do the following: lower the pitch of the "high" head and raise
the pitch of the "low" one*. Repeat this procedure until the top and bottom
heads are tuned to the same pitch. Move on to the next drum.
*Once a head is in tune with itself, it can be tuned higher or lower by
tightening or loosening each tension rod by the same amount. Most of the
time, the head will remain in tune with itself; however, if it should
change, simply fine-tune using the tuning procedure we practiced above.
3) Tune the drums to each other: You're now ready to tune the whole set. The
smallest diameter drums are tuned the highest; the largest diameters, the
lowest. Many drummers like to tune their toms a 4th apart. If you want to
try this tuning, sing the first two notes of the wedding march, "Here Comes
the Bride." "Here" and "Comes" are a 4th apart. Use these notes as a guide.
If you prefer the "free-form" method of tuning your drum, go right ahead…as
mentioned before, there's no right or wrong notes to tune drums. However,
every drum has a range of pitches where it sounds best. Tune it too high and
it'll sound "choked;" tune it too low and it'll sound "flappy." Experiment
until you find the notes that work for you. |
|
|
-
Back to Tech Tips Main Menu - |
|
|
View Basket
Recover Basket
